Specifications

RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA
4 •• RGB Computer Interface Card for TPS/Tilt Panel: TPS-XVGA Operations & Installation Guide - DOC. 5944
for which it was intended, it may lockup the control system which would then
have to be returned to Crestron. Update files with an “S” designator are for the
ST-CP, “V” designator for CEN/CN-TVAV, “W” for CNRACKX/-DP, and
“X” for CNMSX-AV/Pro control systems. Control systems are able to
recognize and reject incorrect update files. However, when updating control
systems, do not ignore any Crestron Viewport warning prompts or messages.
4 The ST-CP control systems do not support loading of firmware or VT Pro-e
files to the TPS-series touchpanels through the RS-232 port of the control
system. In order to load these files to the TPS touchpanel when using these
control systems, either use the RS-232 port on the TPS touchpanel or Ethernet
direct to the panel (assuming the TPS-ENET Ethernet Card is installed).
As of the date of manufacture, this unit has been tested and found to
comply with specifications for CE marking.
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Computer Video Connector Signals
Video Connector Pinouts
PIN DESCRIPTION PIN DESCRIPTION
1 Red video input 9 NC
2 Green video input 10 GND
3 Blue video input 11 NC
4 NC 12 NC
5 GND 13 Horizontal or composite sync
6 GND 14 Vertical sync
7 GND 15 GND
8 GND
NC = Not Connected
Preparation
The TPS-XVGA is shipped within an electrostatic discharge (ESD)
prevention bag that is packed into a shipping box. To minimize possible
damage during shipping, the TPS-XVGA contains packing material
between the fan assembly and the card. This packing material must be