Specifications

12 Inch Lectern/Wall Mounted Touchpanel Crestron Isys™ TPS-5000L
Direct Mounting
The TPS-5000L is a low-voltage unit that can be installed directly into a mounting
surface. Each touchpanel is provided with mounting hardware and accessories, as
shown in the table after this paragraph.
TPS-5000L Supplied Mounting Hardware and Accessories
DESCRIPTION PART NUMBER QUANTITY
Large Metal Mounting Plate MTPL02553-1 2
Small Metal Mounting Plte MTPL02523-1 2
Template OV40049-1 1
Screw, Pan Phillips, #6-32 x 1”L SR06-32-1R0000-3 12
Network Connector (4 Pin Cresnet) JHPS197SG04SR-2 1
Microphone Connector (3 pin) JHPS138SG03SR-1 1
Audio Input Connector (6 pin) JHPS138SG06SR-1 1
NOTE: Refer to Appendix B: Cutout Detail of Supplied Template on page 47 for
cutout dimensions.
Tools/hardware required
#2 Phillips tip screwdriver
Gypsum board saw (or equivalent)
Drill
5/16” bit
# 20 bit
Complete the following installation procedure in the order provided.
1. Locate an area on the wall that is free of miscellaneous wiring and
studs.
2. Make a small hole near the middle of the designated site; verify that the
location is suitable.
3. Fasten cutout template (40049, supplied) to mounting surface; verify
that the template is level.
4. Cut out and remove the traced shape of the mounting surface.
5. Drill four 5/16” holes as marked on template. Refer to "Appendix B:
Cutout Detail of Supplied Template" on page 47 for an illustrative
reference.
6. Drill 12 holes marked "A" on template with #20 bit. Refer to
"Appendix B: Cutout Detail of Supplied Template" on page 47 for an
illustrative reference.
7. Slide one large metal mounting plate through the opening and position
it inside along the top horizontal edge.
8. Position one small metal mounting plate along the top horizontal edge
so that it covers the two center holes marked "A".
9. Use two pan head screws, supplied, to secure the bracket and plate to
the mounting surface. Tighten by hand; do not fully tighten screws.
20 • 12 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-5000L Operations Guide - DOC. 5783A