Specifications

Crestron Isys
®
TPS-G-TPI G-Series Touchpanel Interface
Ports and Pushbuttons
All connections to the TPS-G-TPI interface are made through the ports on the rear
panel. Refer to the illustrations and descriptions that follow.
VGA OUTPUT
Pin 10
Pin 5
Pin 15
Pin 1
Pin 6
Pin 11
A DB15HD female connector is provided for RGB (VGA) output. A touchpanel,
PC monitor or other device would be connected to the VGA OUTPUT for analog
video.
Out
p
ut DB15HD Pinou
t
PIN DESCRIPTION PIN DESCRIPTION
1 Red video output 9 Not Connected
2 Green video output 10 GND
3 Blue video output 11 Not Connected
4 Not Connected 12 Not Connected
5 GND 13 Horizontal or Composite Sync
6 GND 14 Vertical Sync
7 GND 15 Not Connected
8 GND
PHONE
Connect this standard mini phone jack (12 mW, 32 ohm load) to the plug of a 3.5
mm external plug (not supplied) for either a pair of external amplified speakers or
headphones.
RS-232
This 6-pin RJ-11 connector mates with a 9-pin serial port of a PC. The connecting
cable is not supplied. Use this port to establish a direct connection between the
TPS-G-TPI and a PC, mouse or touchscreen input. When a direct connection to a PC
is established, firmware updates and other files can be uploaded to the TPS-G-TPI.
Additionally, the interface’s diagnostic tools and set up screens can be accessed over
the direct connection or a direct connection to a touchpanel. In the event that modular
cables or an RJ-11 to DB9F adapter is not available, the following table and diagram
provide information so that the cable can be fabricated on site. Refer to “RS-232
Menu” on page 18 for RS-232 port configuration settings.
RS-232 Pinouts
PIN # DESCRIPTION
1 CTS
2 GND
3 RXD
4 TXD
5 RTS
6 N/C (Not connected)
16
1
6
Front
Top
Operations Guide – DOC. 6445 Isys
®
G-Series Touchpanel Interface: TPS-G-TPI ¥
7