Specifications
Crestron Isys
®
TPS-G-TPI G-Series Touchpanel Interface
Video Setup Details – Video, S-Video, Component and RGB (continued)
VIDEO SCREEN
CONTROLS
DESCRIPTION
Overscan
3
These controls adjust the amount of video information at the edges
of the image. This part of the video picture is usually beyond the
display capabilities of the screen.
None
3
Sets the video screen so there is no overscan. The amount of used
screen area is smallest in this configuration.
Normal
3
Sets the video screen for normal overscan. This results in more
area of the screen being used.
Max
3
This sets the video screen area to the maximum. The screen area
is largest in this configuration. All video information at the edges is
visible.
Size and Position When RGB is selected as the video source, these controls are
available when the RGB Size and Position button has been
pressed.
Auto Calibration Automatically calibrates the incoming RGB signal for optimal
position, size and phase when Auto button is pressed. Default and
Manual buttons return the controls to default position and allow
manual adjustment respectively.
Position
4
This control allows you to set the position of the video screen the
interface sends to a video device. The arrow buttons move the
screen along the X and Y axis.
Restore Default
Position
4
Returns the video screen to its original position as displayed by the
interface.
Size
4
Allows you to set the size of the video screen in both the vertical
and horizontal directions.
Restore Default
Size
4
Returns the video screen to it original size as displayed by the
interface.
Phase
4
These controls adjust the phase of the RGB signal. Controls are
shown for both course and fine adjustments.
Restore Default
Phase
4
Returns the video signal to its original default phase.
1. Video default is 50% for each of the video parameters (brightness, contrast, red, green, and blue).
2. Adjustment applies to the currently selected video source only.
3. These controls are available only in composite, component and S-video modes. In RGB video, they are
analogous to the Position, Width and Height controls.
4. These controls are available only in RGB video mode.
Operations Guide – DOC. 6445 Isys
®
G-Series Touchpanel Interface: TPS-G-TPI ¥
29