Specifications

Crestron Isys

TPS-G-TPI G-Series Touchpanel Interface

pinouts for straight through and crossover RJ-45 cables. Pins 4, 5, 7, and 8

are not used.

RJ-45 Straight Through Cable – For Connection Through Hub

FROM

COLOR SIGNAL TO PIN SIGNAL

1 White/Orange Tx+ 1 Tx+

2 Orange Tx- 2 Tx-

3 White/Green Rc+ 3 Rc+

6 Green Rc- 6 Rc-

RJ-45 Crossover Cable – For Direct PC Connection

FROM

COLOR SIGNAL TO PIN

SIGNAL

1 White/Orange Rc+ 3 Tx+

2 Orange Rc- 6 Tx-

3 White/Green Tx+ 1 Rc+

6 Green Tx- 2 Rc-

5. Once the cable connections are made, open Crestron Toolbox and click

Tools | Manage Address book to display the “Address Book” window.

6. Select the interface from the address book or click Add Entry and type a

new name for the new device, such as TPS.

7. Click TCP as the connection type. Enter the IP address or hostname of the

interface and click OK.

“Address Book” Window – TCP/IP Setup

8. Click Tools | System Info to display the “System Info” window. From the

pull-down menu at the lower left of the window, select the entry created in

step 7.

If the interface is to communicate with a control system over TCP/IP, an IP table

must be created on the interface to identify the control system(s) it will communicate

with over TCP/IP.

Operations Guide – DOC. 6445 Isys

G-Series Touchpanel Interface: TPS-G-TPI ¥