Installation guide

Crestron TPS-MEM64MB & TPS-MEM128MB Flash Memory
11. Move the jumper to the 3.3V position by placing the jumper
over the center pin and the pin labeled 3.3V as shown in the
following diagram.
Jumper in 3.3V Position
NOTE: The memory expansion module will not work if the jumper is in
the “+5V” position.
12. As shown in the following diagram, locate the memory
socket.
Memory Socket Location
LOCATION
OF MEMORY
SOCKET WITH
MEMORY
MODULE
NOTE
POLARITY
OF MEMORY
MODULE
(NOTCH IN
CORNER OF
BOARD)
SIDE CLIP (ONE
AT EACH END)
13. Press the two metallic side clips of the socket securing the
original module in opposing directions and notice that the
module lifts up slightly.
14. Use even pressure while backing out the original module out
of the socket.
Installation Guide - DOC. 6261 Flash Memory for TPS User Interfaces: TPS-MEM64MB & TPS-MEM128MB • 9