Installation guide

Flash Memory Crestron TPS-MEM64MB & TPS-MEM128MB
Remove Rear Cover
4. To obtain unobstructed access to the memory socket, remove
the expansion cover plate or if previously installed, the
TPS-VIDL-1 or TPS-VIDL-2 video expansion card. Each
procedure is defined in the following sub-steps.
4a. If the expansion cover plate is present, refer to the
following diagram. Using a #1 Phillips screwdriver,
loosen and remove the two screws that secure the
expansion cover plate and remove the plate.
12 • Flash Memory for TPS User Interfaces: TPS-MEM64MB & TPS-MEM128MB Installation Guide - DOC. 6261