Installation guide

Crestron TPS-MEM64MB & TPS-MEM128MB Flash Memory
Jumper in 3.3V Position
NOTE: The memory expansion module will not work if the jumper is in
the “+5V” position.
7. As shown in the following diagram, locate the memory
socket.
Memory Socket Location
ROCKLEIGH, NJ 07647 USA
ELECTRONICS INC.CRESTRON
MIC OUTAUDIO INPUT
R
+
S
R
-
L
+
L
-
S
+
-
S
24 Y Z G
NET
SIDE CLIP
(ONE AT
EACH END)
LOCATION
OF MEMORY
SOCKET
WITH
MEMORY
MODULE
NOTE
POLARITY
OF MEMORY
MODULE
(NOTCH IN
CORNER OF
BOARD)
RS-232
8. Press the two metallic side clips of the socket securing the
original module in opposing directions and notice that the
module lifts up slightly.
9. Use even pressure while backing out the original module out
of the socket.
10. Observe polarity (as shown in the previous illustration) and
insert the new memory module into the socket at a slight
angle.
11. Apply even pressure to the module and level it off, parallel to
the motherboard. The two metallic side clips snap into place
as it becomes seated.
Installation Guide - DOC. 6261 Flash Memory for TPS User Interfaces: TPS-MEM64MB & TPS-MEM128MB • 15