Crestron TPS-XBTP Battery Pack for TPS-XTXRF Operations & Installation Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc.
Crestron TPS-XBTP Battery Pack for TPS-XTXRF Contents Battery Pack for TPS-XTXRF: TPS-XBTP 1 Description .......................................................................................1 Functional Description ..........................................................1 Physical Description ..............................................................2 Leading Specifications.....................................................................3 Handling.............................................
Crestron TPS-XBTP Battery Pack for TPS-XTXRF Battery Pack for TPS-XTXRF: TPS-XBTP Description Functional Description The TPS-XBTP Battery Pack for TPS-XTXRF supplies operating power to a Crestron Isys tilt touchpanel equipped with the optional TPS-XTXRF Two-Way Radio Frequency (RF) Transceiver Module. Installation of the module and battery pack into the touchpanel offers freedom to roam without being confined to a stationary power source.
Battery Pack for TPS-XTXRF Crestron TPS-XBTP Physical Description The TPS-XBTP is housed in a black enclosure with its electrical contacts located on the bottom (see views below). TPS-XBTP Top, Side & Rear Views 5.00 in (12.70 cm) 7.14 in (18.14 cm) 1.40 in (3.56 cm) TPS-XBTP Bottom View NICKEL-MH BATTERY: MUST BE RECYCLED OR DISPOSED OF PROPERLY. CAUTION DO NOT BURN OR PUNCTURE BATTERY. DOING SO COULD RELEASE TOXIC MATERIALS WHICH COULD CAUSE INJURY. DO NOT SHORT CIRCUIT.
Crestron TPS-XBTP Battery Pack for TPS-XTXRF Leading Specifications The following table provides a summary of leading specifications for the TPS-XBTP. Leading Specifications for the TPS-XBTP SPECIFICATION Output Voltage Composition Estimated Operating Time, (new unit with full charge) Estimated Life Optimal Operating Temperature Optimal Storage Temperature Charging Temperature Weight DETAILS 20 VDC (4.
Battery Pack for TPS-XTXRF Crestron TPS-XBTP Handling WARNING: To prevent short-circuiting, use care when handling the TPS-XBTP. NiMH cells have extremely low internal resistance and discharge at high current levels when shorted. As a result, high temperatures can damage the battery pack and may cause personal injury. Avoid accidental shorting of the TPS-XBTP electrical contacts from uninsulated workbenches, tools, bracelets, rings and coins.
Crestron TPS-XBTP Battery Pack for TPS-XTXRF Charging & Discharging NOTE: Typically, the battery pack is good for 500 charge/discharge cycles. Charging To charge the TPS-XBTP: • Use the TPS-XBC Battery Charger; or • Install the TPS-XBTP in a TPS-XTXRF equipped touchpanel that is docked to a powered TPS-XDS Docking Station. NOTE: An external power pack or Cresnet power connected directly to the TPS-XTXRF equipped touchpanel does NOT charge the TPS-XBTP.
Battery Pack for TPS-XTXRF Crestron TPS-XBTP Installation The TPS-XBTP is designed to prevent improper installation. The unit fits only one way in the battery compartment of a touchpanel equipped with the TPS-XTXRF. To install the TPS-XBTP, refer to the following diagram. Note the bottom-center slot of the TPS-XTXRF and insert the battery pack in the touchpanel until it snaps in place. Insert TPS-XBTP into Touchpanel 6 • Battery Pack for TPS-XTXRF: TPS-XBTP Operations and Installation Guide - DOC.
Crestron TPS-XBTP Battery Pack for TPS-XTXRF Removal To remove the TPS-XBTP from a touchpanel equipped with the TPS-XTXRF, press down the battery eject button, allow the battery pack to eject approximately 1/4-inch and remove the pack. See diagram below. TPS-XBTP removal from rear of touchpanel Operations and Installation Guide - DOC.
Battery Pack for TPS-XTXRF Crestron TPS-XBTP Further Inquiries If you cannot locate specific information or have questions after reviewing this guide, please take advantage of Crestron's award winning customer service team by calling the Crestron corporate headquarters at 1-888-CRESTRON [1-888-273-7876]. For assistance in your local time zone, refer to the Crestron website (www.crestron.com) for a listing of Crestron’s worldwide offices.
Crestron TPS-XBTP Battery Pack for TPS-XTXRF Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange, or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number, and return address. 2.
Battery Pack for TPS-XTXRF Crestron TPS-XBTP This page intentionally left blank. 10 • Battery Pack for TPS-XTXRF: TPS-XBTP Operations and Installation Guide - DOC.
Crestron TPS-XBTP Battery Pack for TPS-XTXRF This page intentionally left blank. Operations and Installation Guide - DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations and Installation Guide - DOC. 5845 03.02 Specifications subject to change without notice.
