User Guide

Two-Way RF Transceiver Module Crestron
TPS-XTXRF
NOTE: If the TPS touchpanel is equipped with an optional TPS-XVGA or
TPS-XVGA-BV expansion card, the fan assembly on the card must be removed
because it interferes with the placement of the TPS-XTXRF. Removal will not
introduce cooling problems because the TPS-XTXRF has fans for adequate air
circulation. Therefore, there is no need to re-install the fan. Continue to the next
step.
If a TPS-XVGA or TPS-XVGA-BV IS NOT installed, proceed to step 11 of this
procedure.
9. Refer to the diagram below. At the TPS-XVGA or TPS-XVGA-BV,
disconnect the fan electrical connector from the PCB connector of the
card.
CAUTION: An early generation the TPS-XVGA or TPS-XVGA-BV did not have a
connector between the fan assembly and the card. If a connector is not present, the
fan electrical wires must be cut flush to the PCB to avoid introducing a short, which
can damage the unit.
Installation Diagram 3 of 12 - Remove Fan Assembly Electrical Connector
10. Refer to the diagram on the next page. Using a #1 Phillips screwdriver,
loosen and remove the two screws that secure the fan assembly (fan on
metal plate) to the TPS-XVGA or TPS-XVGA-BV. Remove the fan
assembly from the card.
8 • Two-Way RF Transceiver Module: TPS-XTXRF Operations & Installation Guide - DOC. 5844