User Guide

Two-Way RF Transceiver Module Crestron
TPS-XTXRF
12. Refer to the diagram below. Making sure that the RED wire at one end
of the large TPS-XTXRF connector faces in toward the center of the
unit, attach the TPS-XTXRF large connector to P11 (connector on the
touchpanel) so that all pins mate.
CAUTION: The touchpanel can be damaged when power is applied, if the large
TPS-XTXRF connector is mated incorrectly (any pin is exposed).
Installation Diagram 6 of 12 - Attach Large TPS-XTXRF Connector
RED
WIRE
13. Refer to the diagram below. To make final installation easier, spread
the wires of the large connector slightly apart.
Installation Diagram 7 of 12 - Spread Large Connector Wires
14. Refer to two diagrams on the next page. Making sure that the RED
STRIPE end of the ribbon cable faces in toward the center of the unit,
attach the TPS-XTXRF ribbon cable connector to P8 (connector on
the touchpanel).
NOTE: The TPS-XTXRF ribbon cable connector has a key to ensure a proper fit
with the small connector of the touchpanel. When installing the ribbon cable
connector, verify that the key slides into the slot of the mating connector.
10 • Two-Way RF Transceiver Module: TPS-XTXRF Operations & Installation Guide - DOC. 5844