User Guide

Crestron
TPS-XTXRF
Two-Way RF Transceiver Module
Installation Diagram 8 of 12 - TPS-XTXRF Ribbon Cable Connector Detail
SLOT
RED STRIPE
KEY
Installation Diagram 9 of 12 - Attach TPS-XTXRF Ribbon Cable Connector
NOTE: If an optional TPS-XVGA or TPS-XVGA-BV expansion card was
temporarily removed to make installation of the TPS-XTXRF cable connectors
easier, re-install the card. Tighten the card mounting screws to finger-tight then
using a #1 Phillips screwdriver (1.5” length), tighten an additional 1/8-turn.
15. Refer to the diagram on the next page. Align the TPS-XTXRF threaded
screw inserts with the holes of the touchpanel base plate and lower the
TPS-XTXRF onto the touchpanel base.
Operations & Installation Guide - DOC. 5844 Two-Way RF Transceiver Module: TPS-XTXRF • 11