User Guide

Crestron
TPS-XTXRF
Two-Way RF Transceiver Module
19. Refer to the diagram below. By hand, thread the antenna onto the
antenna mounting post to finger-tight.
Installation Diagram 12 of 12 - Install Antenna
20. Apply power to the touchpanel.
There are four ways to operate the TPS-XTXRF equipped touchpanel.
First, a charged TPS-XBTP Battery Pack can be installed into the
touchpanel directly. Secondly, the TPS-XTXRF equipped touchpanel
can be properly positioned on the TPS-XDS Docking Station with or
without a TPS-XBTP installed. The touchpanel can also be powered
directly via the PW-2420RU (without a docking station). Finally, the
unit can be powered via a Cresnet connection. However, keep in mind
that a Cresnet connection disables the RF communication capabilities
of the unit; the panel continues to operate as a wired touchpanel if it is
correctly defined in the SIMPL program. Power must be re-applied
using one of the first three mentioned methods to take advantage of RF
communication.
NOTE: For further information about the TPS-XBTP and TPS-XDS, consult their
Operations Guide (Doc. 5845 and 5846, respectively). The latest versions of the
guides can be obtained from the Downloads | Product Manuals section of the
Crestron website (www.crestron.com
).
Operations & Installation Guide - DOC. 5844 Two-Way RF Transceiver Module: TPS-XTXRF • 13