User Guide

Crestron
TPS-XTXRF
Two-Way RF Transceiver Module
Two-Way RF Transceiver Module:
TPS-XTXRF
Description
Functional Description
The TPS-XTXRF Two-Way radio frequency (RF) Transceiver Module is an
optional feature designed for use with certain Crestron Isys™ tilt touchpanels
(TPS-5000, TPS-6000, and TPS-4500 – refer to note on this page for this unit).
Equipped with the TPS-XTXRF, the touchpanel is converted to an RF two-way
wireless transceiver that communicates through an RF gateway/transceiver, TPS-
RFGWX (sold separately) to the Crestron remote control system (herein referred to
as the Cresnet system). The two-way communications provide the control of
Crestron-controlled devices and provide dynamic onscreen feedback for real-time
confirmation of commands. Up to 15 touchpanels can communicate with one TPS-
RFGWX. The RF signals can travel from a minimum of three feet up to a maximum
of 150 feet. The location and the antenna position of the TPS-RFGWX are important
factors in the RF performance. The range of the touchpanel is also dependent on its
placement and the construction of the building in which it is used.
Crestron Identification Label
TPS-4500
ZA11323
C000000
NOTE: The TPS-XTXRF can be installed onto most TPS-4500 tilt touchpanels.
There is one version that cannot accept the two-way RF transceiver module. Refer to
the barcode label on the underside of the touchpanel base for identification.
TPS-4500 tilt touchpanels marked with number ZA11323 in the lower-left section
of the label are not compatible with the TPS-XTXRF.
Functional Summary
• Converts an Isys tilt touchpanel to an RF two-way wireless
transceiver
• RF range is 3 to 150 feet depending on location and the surroundings
• Up to 15 RF-enabled touchpanels can communicate with a single
TPS-RFGWX
• Maintains sleek, ergonomic design and unique configuration
capabilities of the Isys panel (i.e., video, graphics, and Ethernet)
Operations & Installation Guide - DOC. 5844 Two-Way RF Transceiver Module: TPS-XTXRF • 1