User Guide
Install the Mounting Bracket
The TSW-570 uses a different mounting bracket than the TSW-770 or
TSW-1070. The procedures for installing each mounting bracket are
described in the following sections.
Install the TSW-570 Mounting Bracket
The TSW-570 can be mounted into drywall an other surfaces, or it can be
mounted onto a wall stud. When mounted into drywall or other surfaces,
the touch screen protrudes XX in. (XX mm)from the mounting surface.
NOTE: Additional mounting options are possible using the TSW-UMB-70
universal mounting bracket, TSW-UMB-70-PMK preconstruction
mounting kit, TSW-UMB-70-BBI wall mount back box, TSW-570-MSMK
multisurface mounting kit, or TSW-570/770-RMK-1 rack mount kit. For
more information, refer to the product pages at www.crestron.com.
Preconstruction Installations
To install the TSW-570 mounting bracket in preconstruction applications,
use standard drywall nails or screws (not included)to attach the
TSW-UMB-70-PMK mounting bracket to a wall stud.
NOTE:Allow an air gap of at least 12 in. (305 mm)in the wall cavity above
and below the touch screen for heat dissipation.
Postconstruction Installations
To install the TSW-570 mounting bracket in postconstruction
applications:
1. Use the TSW-UMB-70-PMK mounting bracket as a cutout template
by turning the bracket to face the wall, ensuring it is level, and tacking
it the wall temporarily with finishing nails (not included)through the
smaller holes around the cutout opening.
2. Create an opening in the surface by tracing the cutout opening with an
appropriate drywall saw.
3. Loosen the two screws on the TSW-UMB-70 mounting bracket.
4. Install the TSW-UMB-70, bottom side first, into the opening.
2
TSW-570/TSW-770/TSW-1070
QuickStart
5 in., 7 in., and 10.1 in. Wall Mount Touch Screens
PRELIMINARY