User Guide

5. Push the rear half of the mounting bracket back so that it is seated
behind the mounting surface completely.
6. Ensure the front of the TSW-UMB-70 is level, and then tighten the two
bracket screws.
Install theTSW-770/TSW-1070 Mounting Bracket
The TSW-770 and TSW-1070 install over a standard 2-gang or 3-gang
U.S. electrical box, a 2-gang European electrical box, or a 2-gang U.K.
electrical box. The touch screen may also be installed into wooden paneling
or furniture with a XX in. (XX mm) high by XX in. (XX mm)wide
rectangular cutout.
When installed, the touch screen protrudes XX in. (XX mm) from the
mounting surface, leaving no visible screws.
NOTES:
l Additional mounting options are possible using the TSW-UMB-70
universal mounting bracket, TSW-UMB-70-PMK preconstruction
mounting kit, TSW-UMB-70-BBI wall mount back box,
TS-770/1070-MSMK series multisurface mounting kits,
TS-770/1070-MUMK mullion mounting kit, TSW-770/1070-RMB
series retrofit mounting brackets, or TSW-770/1070-RMK series
rack mount kits. For more information, refer to the product pages
at www.crestron.com.
l Installing the mounting bracket to an electrical box is required only
if one of the mounting solutions above is not used. Refer to the
mounting solution documentation at www.crestron.com/manauls.
To mount the touch screen into an electrical box, use the appropriate
screws (four 6-32x 3/4in. screws, four M3x16mm screws, or two
M3.5x25 mm screws) to attach the mounting bracket to the electrical
box as shown in the following illustrations:
NOTE:For U.S. installations, use a #2 Phillips screwdriver. For
European or U.K. installations, use a #1 Phillips screwdriver.
3
TSW-570/TSW-770/TSW-1070
QuickStart
5 in., 7 in., and 10.1 in. Wall Mount Touch Screens
PRELIMINARY