User Guide

To remove the touch screen after installation, use the metal prong to
push down on the security bracket tabs as shown in the following
illustration while gently pulling the touch screen away from the mounting
bracket.
Connect the Touch Screen
Route all necessary cables through the rear of the mounting bracket, and
then make connections to the side of the touch screen rear housing as
shown in the illustration below.
Observe the following when connecting the touch screen:
l Power and data connection is provided to the touch screen by a single
Ethernet cable. A Crestron PoE (Power over Ethernet) power supply,
such as the PWE-4803RU, or a PoE-capable network switch is
recommended (both not included).
l The USB ports are used to connect compatible Crestron LED
accessories to the touch screen.
NOTE: The TSW-770 may use either PoE or PoE+ to supply power
to compatible LED accessories over USB; the TSW-1070 must use
only PoE+ to supply power to LED accessories over USB.
l Apply power after all connections have been made.
5
TSW-570/TSW-770/TSW-1070
QuickStart
5 in., 7 in., and 10.1 in. Wall Mount Touch Screens
PRELIMINARY