User Guide

Crestron WMKB-1000L Wall Mount Bracket Kit
5. Use four pan head screws, supplied, to attach two mounting brackets to the touchpanel
(refer to illustration after this step). Do not tighten screws. The screw threads should
catch the mounting brackets, but not pass more than 1/16" through to the other side of the
opening.
Mounting Bracket/Touchpanel Assembly
6. Attach the Cresnet cable in the wall to the connector on the back of the touchpanel. If
necessary, refer to the latest revision of the Series 1000 Operations Guide (Doc. 5813) for
connector and hookup details. The guide is available from the Crestron website
(www.crestron.com).
7. Position the mounting bracket/touchpanel assembly (less the plastic buttons and cover)
over the opening and apply equal pressure on the four screw heads of the touchpanel until
the assembly slides into place.
CAUTION: Do not apply excessive pressure to the touchscreen display during
installation. Doing so can crack the screen and damage the touchpanel.
8. Tighten four screws until mounting bracket/touchpanel assembly is secure within the
opening.
9. Install the plastic buttons by firmly pressing them into place. If buttons are engraved, be
sure to match button engraving with button functionality.
10. Firmly press on the plastic cover over the touchpanel (refer to illustration after this step).
NOTE: If necessary, refer to the latest revision of the Series 1000 Operations Guide
(Doc. 5813) for a touchpanel removal procedure.
2 • Wall Mount Bracket Kit: WMKB-1000L Installation Guide - DOC. 6283