Specifications

Crestron V12 & V15 V-Panel™ 12” and 15” Touchpanel Displays
Setup
Configuring the V-Panel
The V-Panel is configured from the setup menu using the DGE Digital Graphics
Engine (sold separately). Refer to the Operations Guide that came with your DGE.
Hardware Hookup
Ventilation
The V12/15 should be used in a well-ventilated area.
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications.
Connect the Device
Make the necessary connections as called out in the illustration that follows this
paragraph. Apply power after all connections have been made.
When making connections to the V12/15, use Crestron power supplies for Crestron
equipment.
Hardware Connections for the V12/15 (V15 Shown)
DM INPUT, D & M:
To DGE
DM OUT, D & M
24 A B G:
To DGE
DM OUT 24 A B G
USB:
To Mouse
or Keyboard
NOTE: For wiring between the DGE and V-Panel, use DM-CBL DigitalMedia
cable, CresCAT
®
D or quality CAT5e/CAT6 cable. Do NOT use low skew cable.
That maximum allowable cable length is 200 feet (61 meters) for DM-CBL, 150 feet
(46 meters) for others.
NOTE: DMNet wiring and Cresnet
®
wiring are not compatible.
Tilt Tension Adjustment
Tilt tension on the V12 and V15 is preset at the factory to allow the panel to be tilted
anywhere within its 35 degree tilt range and maintain its position during use. To
tighten tilt tension or to fix the panel at a given tilt position, use the three Allen
screws accessed through the hole in the touchpanel base, as shown in the following
illustration.
Operations Guide – DOC. 6806B V-Panel™ 12” and 15” Touchpanel Displays: V12 & V15 • 23