Instructions / Assembly

2 3
HT-785
HT-785
IV. Safety Instructions
V. Inflation Operation
Inflation inlet
PSI selection
Power button
Air inlet
DC plug
Air t ap
Hose
Flexible conduit adaptor
1
2
3
4
5
6
7
8
8
6
7
Warning: In order to reduce the risk of injury, please keep children
away from the pump.
Warning:
Before moving, maintaining, repairing or adjusting this product,
make sure that it is not plugged into the socket.
Warning: If the power wire is damaged do not use the pump. Contact us
first at [e-mail] for help.
Warning: If you are standing in a place with water or your hands are wet,
please don't plug or pull the DC plug.
Warning: Before inflating, please check the maximum allowed pressure
of the product you are inflating. Do not go over this pressure or try to pump
more then allowed. Doing this will damage the pump and item you are inflating.
Most inflatable paddle boards should not go over 15 PSI.
Warning
: Before using, please check the cigarette lighter socket to
make sure that there is no rust or residue inside. Damaged or dirty
sockets can cause overheating of the product, or the power source.
Always make sure it is clean.
Warning:
Please follow the instructions of this booklet. If you have
Connect the Flexible adaptor (8) from the hose with
the air pump inflation inlet (1), and twist clockwise to tighten it,
as Figure 1.
Install the other end of the hose with the suitable adaptor that fits your
product. There are several adaptors depending on which item you will
be inflating. Twist clockwise to insert into the inflatable paddle board.
To replace the adaptors, simply spin counter clockwise to remove.
Plug the DC plug into the 12V DC socket.
Toggle the adjustment knob (2) to select the pressure value you need.
After completing the steps above, press the power switch button (3) to
start inflation.
Figure 2
Figure 1
any questions, you can always email us at [e-mail]