System information
How to Program Features
The vehicle ignition key and the Valet Switch are used to enter the Programming
Mode, then the controller
or
transmitteris used to change features. Once the system
is in Programming Mode, a 10 second period without programming activity will
cause the system to automatically exitProgramming Mode. Features canbe selected
in
any order as desired.
Enter Programming mode:
Turn the vehicles's ignition on.
Turn the ignition off.
Within 5 seconds, Press & Release the Valet Switch 5 times.
•The siren will chirp then sound briefly and the Status Light will light
steady to confirm that the system is entering Programing Mode.
Access a Feature:
h-lI:Jt~1
Within 10 seconds, Press & Release the Valet Switch the same
number
of
times as the desired feature's number.
• The siren will chirp and the Status Light will flash off the same number
of
times as the Valet Switch was pressed to indicate the feature number
accessed.
Change the Feature:
After accessing the desired feature, within 10 seconds Press &
Release the appropriate controller
or
transmitter button.
• Pressing the
"armllock"
button typically turns the feature on; or sets the
feature's first option. The siren will chirp once when this button
is
pressed.
• Pressing the
"disarm/unlock"
button also typically turns the feature off;
or,
sets the feature's second option. The siren will chirp twice.
• Many features have third, and even fourth setting options. Pressing the
"II" and "III" buttons select these options. Confirmation chirps when
these buttons are pressed are three and four chirps respectively.
To Access and Change further Features:
If
there are more features to be programmed, within I0 seconds
of
the previous action Press & Release the Valet Switch the same
number
of
times as the next desired feature's number.
• Again the siren will chirp and the Status Light will flash
as
many times
as
the Valet Switch was pressed to indicate the new feature number which
is
now accessed. Then use the controller or transmitter as described in
Step 5
to
change the newly accessed feature
as
desired.
Page - 25