Operating Instrudtion 2-Way AM/FM Paging Remote Alarm, Keyless Entry System & Engine Starting System with 1-Way Sidekick Remote Control CS-2012TW1

ManualsBrandsCrimestopper Security Products ManualsAutomobile AlarmCS-2012TW1

CS-2012TW1

Super Rage™

2-Way AM/FM Paging Remote Alarm, Keyless Entry System & Engine Starting

System with 1-Way Sidekick Remote Control

OPERATING INSTRUCTIONS

CONGRATULATIONS on your choice of a CS-2012TW1 Super Rage™ Alarm & Remote Engine Starter by

Crimestopper Security Products Inc. This booklet contains the information necessary for operating your

system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc.

*IMPORTANT INFORMATION: Primary and Optional Features

-PRIMARY: These are features that must be connected in order for the system to operate properly i.e. Power,

Ground, Flashing Lights, Siren, LED, etc.

-OPTIONAL: Optional features are connected only if desired or agreed upon by the installing dealer i.e. Door

Locks, Horn Honk, Dome light illumination, Trunk Pop, etc. These features may require additional parts and

labor charges. Consult with your installer about these features before installation.

CONTACT INFORMATION:

TECHNICAL SUPPORT (800)-998-6880

Monday - Friday 8:00am - 4:30pm Pacific

Website: www.crimestopper.com

E-mail: tech-support@crimestopper.com

CRIMESTOPPER

SECURITY PRODUCTS, INC.

1770 S. TAPO STREET

SIMI VALLEY, CA. 93063 REV. C 05.2005

This device complies with FCC Rules part 15. Operation is subject

to the following two conditions: 1) This device may not cause

interference, and (2) this device must accept any interference that

may be received, including interference that may cause undesired

operation. The manufacturer is not responsible for any radio or TV

interference caused by unauthorized modification to this

equipment. Such modification could void the user's authority to

operate the equipment.

Summary of content (20 pages)

PAGE 1
CS-2012TW1 Super Rage™ 2-Way AM/FM Paging Remote Alarm, Keyless Entry System & Engine Starting System with 1-Way Sidekick Remote Control OPERATING INSTRUCTIONS CONGRATULATIONS on your choice of a CS-2012TW1 Super Rage™ Alarm & Remote Engine Starter by Crimestopper Security Products Inc. This booklet contains the information necessary for operating your system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc.
PAGE 2
TABLE OF CONTENTS Operation Cautions & Warnings……..………..………………………………………………………….….………2 2-Way LED Paging Remote………………………………………………………….………..….……….…..……..3 1-Way “SideKick” Non-Paging Remote……………….………..………………………………….……..…..……..4 Paging Tones & LEDs……….………………………………………….………..…………………..….….…..…….5 . Operating Instructions - Alarm……………………………………………………….………..……………..……..6-9 LED Diagnostics………………..…………………………………………………………………….………..…..….9 Remote Engine Control………………………...…………………………………………………….………...…..
PAGE 3
2-WAY LED PAGING REMOTE PAGER / REMOTE TRANSCEIVER: The hand-held remote transceiver is used to send and receive information from the vehicle. The Control Module transmits confirmation signals from the vehicle to your pager. Your range will vary depending on location, terrain, and local RF noise/interference. This system is not guaranteed to page you if you are behind concrete walls, underground, in a large structure, or in an area with high levels of electronic interference.
PAGE 4
1-WAY “SIDEKICK” NON-PAGING REMOTE The 1-Way sidekick remote adds flexibility to your CS-2012TW1. You have the convenience of operating your system without needing to carry the pager remote. The “Sidekick” remote offers all of the same operation features remote, except the range is lower and it will not receive page-back confirmations from the vehicle. See diagram at right for Sidekick 1-Way remote operation. BUTTON 1(Lock Symbol): • Press and release to Arm/Lock system.
PAGE 5
PAGING TONES & LEDs CS-2012TW1 PAGING LEDs Yellow LED: Shock sensor, Trunk pop FEATURE LOCK UNLOCK AUX #1 AUX #2 PANIC BUTTON #1 (Lock) #2 (Unlock) #3 (Trunk) #3 (Trunk) #1 (Lock) REMOTE START #4 (Start) REQUEST ENGINE RUNNING CONFIRMATION TURN OFF ENGINE #4 (Start) (From remote) DOOR VIOLATION HOOD/TRUNK VIOLATION SHOCK VIOLATION PRE-WARN IGNITION VIOLATION Blue LED: Remote Start, Ignition Red LED: Door Trigger Orange/Green LED: Lock/Unlock, Hood/Trunk PAGE-BACK: BEEPS 1X, then 1X 1X, then 2X 1X, th
PAGE 6
OPERATING INSTRUCTIONS - ALARM Active Arming / Locking: Press and release button #1 (Lock symbol) on the transmitter. The system will arm and confirm with one siren chirp, one light flash, and the LED will begin to flash. Power locks will lock (if equipped). Starter disable circuit will turn on. After a short delay to allow the vehicle and electronics to settle, the system is completely armed. Disarming: / Unlocking Press and release button #2 (Unlock symbol) on the transmitter.
PAGE 7
OPERATING INSTRUCTIONS - ALARM Alarm Triggering An intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for 1 minute. After 1 minute the trigger cycle will automatically stop and alarm will remain armed to continue protecting the vehicle. If a door is left open after an intrusion then the unit will cycle a maximum of 5 minutes and continue to protect the other un-tampered or unopened zones.
PAGE 8
OPERATING INSTRUCTIONS - ALARM Remote AUX. Output 2 (Optional) This system contains a second auxiliary output to activate other accessories or devices. To activate the systems’ Second Auxiliary Output, press and hold Button #3 (Trunk Symbol) on the transmitter for more than 2 seconds. This is a momentary output that will stay active as long as the remote button is held down. Remote output #2 requires programming before operation.
PAGE 9
OPERATING INSTRUCTIONS - ALARM Optional M.A.P. (Mobile Accessories Protection) This system can be programmed to provide Crimestopper’s unique M.A.P. (Mobile Accessories Protection) feature that allows you to prevent unauthorized access of your vehicles Audio, Cellular, Navigation, or Entertainment systems. This feature is OPTIONAL and will requires extra parts and labor for installation. Consult your installation dealer about MAP before or during installation.
PAGE 10
REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM: SOLID START FLASH 1X AFTER IGN 3 SEC. THEN SOLID STARTER REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2nd and 3rd time. For hard starting engines, the unit will allow a starter crank time of up to10 seconds maximum.
PAGE 11
REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock/Disarm system (If armed) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park. 4) Remote starter will reset instantly when the brake is pressed. Parking lights will turn off and the ignition key is now controlling your vehicle.
PAGE 12
REMOTE ENGINE CONTROL INFINITY RUN MODE This mode allows the vehicle’s engine to remain running INDEFINITELY. This mode can be beneficial to law enforcement vehicles or commercial vehicles that need to remain running unattended for long periods of time. INFINITY RUN MODE – EXITING THE VEHICLE: 1) Follow steps on the last page for “IDLE DOWN MODE - EXITING THE VEHICLE”, except press the remote start button TWO times at STEP #1.
PAGE 13
REMOTE ENGINE CONTROL TIMED SELF START MODE This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programmed run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern. THE VEHICLE MUST BE OUTDOORS OR IN A WELL VENILATED AREA. TIMED SELF-START MODE – EXITING THE VEHICLE: 1) Have engine running with the Key, then press and release the Start button. 2) Within the next 10 seconds press the valet/program button once.
PAGE 14
OPTIONAL TURBO TIMER MODE OPTIONAL TURBO TIMER MODE: IMPORTANT NOTE: This mode requires the use of an extra part called a momentary switch or button that is not included with the kit. Check with your installer about adding this feature. The optional Turbo Timer mode allows the your system to keep your vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors remotely [if you own a Turbo or Turbo Diesel].
PAGE 15
ANTI CARJACK PROTECTION REMOTE OPERATED CARJACK PROTECTION This feature provides Active Carjack protection through the remote control. When the Ignition is on (vehicle is running), press and hold the #1 LOCK Button and #3 TRUNK Button for 3 seconds. The parking lights will flash 2 times and the LED will begin to flash rapidly to confirm the beginning of a Carjack countdown.
PAGE 16
TRANSMITTER PROGRAMMING Note: Remotes Transmitters come pre-programmed from the Factory. When re-learning remotes or adding remotes, ALL your system’s remote codes must be learned at time of programming!! This system allows storage of up to 4 different remote codes in memory. 1. 2. 3. 4. Open hood (ground the Blue hood pin wire if no hood pin is installed.) Turn key to the ON position. (Starting the vehicle is not necessary.) Press Program/Valet button 4 times.
PAGE 17
PAGER REMOTE BATTERY REPLACEMENT CS-2012TW1 PAGER (LOW BATTERY WARNING) The CS-2012TW1 Pager LED has a low battery warning system. When the battery voltage is low, the Orange & Green LEDs flash 6 times with any button that is pressed. We recommend replacing the battery for proper operation. To replace the battery, simply unlock and slide open the battery door on the back of the LED remote.
PAGE 18
TROUBLESHOOTING: “BEFORE YOU CALL SECTION” Before calling your dealer or Crimestopper, read the following for tips that may remedy the problem. RANGE QUESTIONS (2-Way Pager/Remote): Your CS-2012TW1 system uses Am & FM High-Frequency signals to send/receive data between the pager and the vehicle and from the vehicle to the remote for state-of-the-art operation. 1) Under normal operation, the distance from the vehicle-paging-the-remote will be greater than that from the remote-to-the-vehicle.
PAGE 19
TROUBLESHOOTING cont. UNIT FLASHES THE LIGHTS ONCE AND WILL NOT ATTEMPT A REMOTE START: The system is in Valet mode. Check the systems LED light and if it is on solid Red LED (with doors closed) then the system is in VALET mode. To exit VALET, turn the Ignition on, press and hold valet/programming button for about 5 seconds until LED goes out. Unit is now out of valet mode and should perform a remote start. SYSTEM DOES NOT RESPOND TO THE REMOTE CONTROL: 1.
PAGE 20
www.crimestopper.com email@crimestopper.com Phone (800) 998-6880 FAX (805) 581-9500 © 2005 Crimestopper Security Products ONLINE TECHNICAL SUPPORT www.crimestopper.com/techweb03.