Operating Manual

To eliminate siren chirps, turn the ignition on and press the transmitter’s remote start button for about 3 seconds.

You will hear a short double chirp. After the ignition is turned off, there will be no siren chirps for arm, disarm and

remote start engage/reset confirmation. To revert back to siren chirps, perform the same procedure (there will

be 2 short double chirps when re-enabling chirps).

ACTIVE RE-ARM PROGRAMMING:

To disable this feature, turn the ignition on and press the transmitter’s lock button for about 3 seconds. 2 siren

chirps will sound confirming the feature has been disabled. To re-enable active rearming, perform the same

procedure (only 1 siren chirp will sound).

REMOTE START PROGRAMMING OPTIONS

The 4-position dipswitches are used to select Remote Start options as follows:

Dip Switch Number Settings

#1 Tach/Tachless or Vacuum ON = Tach/Tachless OFF = Vacuum

#2 Crank Time (.8 or1.25 Sec.) ON = .8 Sec. OFF = 1.25 Sec.

#3 Gas / Diesel ON = Gas OFF = Diesel

#4 Engine or Tachless Monitor ON = Tachless OFF = Engine Monitor

TACH/TACHLESS MODE:

In Tach/Tachless Mode, the selection of dip switch #4 determines if the system will be monitoring the gray Engine

monitor wire or if no wire will be used (Tachless Mode).

VACUUM MODE:

In Vacuum Mode (switch #1 off), connect the Yellow Vacuum Monitor wire to a vacuum switch (not included)

which connects to an engine vacuum hose. When there is no vacuum (engine not running), a ground will be

present and the starter will crank. When vacuum is present (engine running), the switch will activate removing the

ground.

REMOTE START PROGRAMMING OPTIONS

CRANK TIME: