Instruction Manual

7
roll
pitch
yaw
SCREEN
Tighten pre-installed thumb screw and attach at least one of two retaining screws (F)
on the opposite side of the housing.
Apretar pre-instalado tornillo de mariposa y adjuntar al menos uno de los dos tornil-
los de jación (F) En el lado opuesto de la carcasa.
Serrer la vis à oreilles pré-installé et xer au moins une des deux vis de xation (F) Sur
le côté opposé du boîtier.
3-2
INSTALL PROJECTOR
4-1
MAKE ADJUSTMENTS-YAW
Adjust the yaw by turning the knob labeled “yaw”
Ajuste el derrape girando el botón marcado “guiñada”
Réglez le lacet en tournant le bouton étiqueté “lacet”
(F)
(K)
Screen
JR3XL-0001