Use And Care Manual

Reversing Door (Option)
9
RZE43@@(EN)_냉동고.indd 9
2021-02-26 오후 5:33:36
Tools Required :
• 5/16”end wrench, Screwdriver
Note
•
Before reverse door, do not forget to unplug the freezer
Disassemble using a wrench and screwdriver.
Open door and lift.
Place door on a non-scratching surface.
Remove the bottom hinge plate and assemble it
on the opposite side.
Note the location of washer
Washer
Remove the door switch and assemble it to the
enclosed COVER HINGE L.
Separate the bushing and door stopper andassemble
on the opposite side.
Door stopper
Bushing
Remove the sealing gasket from freezer door,
noting orientation during removal.
Rotate 180 degrees and reinstall by alighing to
groove and firmly pressing around the perimeter,
from bottom to top.
Make sure gasket is fully
setaed into door
groove.
Assemble using a wrench and screwdriver.
Door
switch
5/16”
1
2
3
4
5
6
7