Use and Care Manual

-40- -41-
dry thoroughly, and replace Sealing Gasket in Pressure Lid
before use. Leave the Pressure Lid upturned for storage, as
this will also extend the life of the gasket. Sealing Gasket
may need to be replaced every 1 – 2 years depending on
regular use. Contact Crock-Pot
®
customer service or visit
www.crockpot.com to order replacement parts.
Steam Release Valve
Ensure the Steam Release Valve (see Figure 1) is clear from
debris before you begin using the Cooker. Remove the valve
(see Figure 7) and gently clean. Ensure it is completely dry
before replacing.
Steam Release Valve Cover
The Steam Release Valve Cover is on the underside of the
Pressure Lid (see Figure 8). Ensure it is clear from debris
before you begin using the Cooker. To clean, carefully pull
the cover off and clean using warm, soapy water. Press the
cover back into its place after cleaning is complete.
CARE AND CLEANING (CONT.)
Figure 7
Valve REMOVE
UNDERSIDE OF Pressure Lid
Bobber Valve
Gently press the valve up and down 2-3 times and ensure it
is clear from debris before you begin using the Cooker.
Lid Lock Pin
Gently press the pin and ensure it is clear from debris before
you begin using the Cooker.
Crisping Lid
Wait for the Cooker to cool. Use warm soapy water on a
damp sponge and wipe down the Heater Guard and outside
of the Crisping Lid.
CAUTION: Never fully submerge the Crisping Lid in water.
Note:
1. Condensation may collect inside the Heating Base under
the removable Cooking Pot. This is normal. Allow to
cool, and then dry using kitchen cloth.
2. Always make sure that each component (pot, valves,
gasket, etc.) is completely dry before you put back into
the Cooker.
Figure 8
CARE AND CLEANING (CONT.)
Bobber Valve
Steam Release Valve
Cover