Operation Manual

6
STARTING (DIESEL UNITS)
STEP 1 – Set speed control to low speed.
STEP 2 – Pull recoil starter rope until resistance is felt.
STEP 3 – Bracing foot against engine, pull recoil starter rope with both hands.
IMPORTANT: Do not pull recoil starter rope to the end as it may cause damage. When the
rope is pulled out, release the rope slowly. Do not let the rope snap back.
OPERATION
CAUTION! – Poisonous fumes. Start and operate only in a well-ventilated area. Be careful
with hot components, mufflers and other engine parts are hot during operation. Do not
touch them.
STEP 1 – Adjust throttle lever to the desired speed.
STEP 2 – Follow the pattern illustrated below during operation.
- Smooth partially set floor surface; operate the machine with blades fattened.
For a luster finish, operate with the blades slightly tiled. Over tilted blades on
unset floor with create a wavy surface.
- Floor that has completely set is difficult to smooth. If this is the case, tilt blades
as high as possible. Sprinkle water on the floor beforehand.