Standalone Keypad Access Control User Manual Please read the manual carefully before use this unit
1. Packing List Name Quantity Remarks Keypad 1 User manual 1 Screw driver 1 Φ20mm×60mm,Special for keypad Rubber plug 2 Φ6mm×30 mm, used for fixing Self tapping screws 2 Φ4mm×28 mm, used for fixing Star screws 1 Φ3mm×6mm, used for fixing Please ensure that all the above contents are correct. If any are missing please notify the supplier of the unit. 2.
. Description The unit is single door multifunction standalone access controller or a Wiegand output keypad or card reader. It is suitable for mounting either indoor or outdoor in harsh environments. It is housed in a strong, sturdy and vandal proof Zinc Alloy electroplated case which is available in either a bright silver or matt silver finish. The electronics are fully potted so the unit is waterproof and conforms to IP68.
Waterproof Conforms to IP68 Adjustable Door Relay time 0 -99 seconds Adjustable Alarm Time 0- 3 minutes Wiegand Interface Wiegand 26 bit Wiring Connections Electric Lock, Exit Button, External Alarm,External reader 6.
Purple COM Orange NC Relay Public end, connect GND Relay Closed end(connect negative electric lock "-") common power supply diagram: special power supply diagram:
8. To Reset to Factory Default a. Disconnect power from the unit b. Press and hold # key whilst powering the unit back up c. On hearing two “Di” release # key, system is now back factory settings Please note only installer data is restored, user data will not be affected 9. Anti Tamper Alarm The unit uses a LDR (light dependent resistor) as an anti tamper alarm. If the keypad is removed from the cover then the tamper alarm will operate. 10.
Setting the working mode: Set valid card only users 3 0 # Entry is by card only Set valid card and PIN users 3 1 # Entry is by card and PIN together Set valid card or PIN users 3 2 # Entry is by either card or PIN (default) To add a user in either card or PIN mode, i.e. in the 3 To add a Pin user 1 2 # User ID number mode. (Default setting) # PIN # The ID number is any number between 1 & 2000. The PIN is any four digits between 0000 & 9999 with the exception of 1234 which is reserved.
To delete a card user by card. Note users 2 Read Card # can be deleted continuously without exiting programming mode To delete a card user by user ID. This 2 User ID # option can be used when a user has lost their card To delete a card user by card number.
For a card and PIN user 11.2 Read card then enter PIN # Door Settings Relay Output Delay Time To set door relay strike time * Master code # 4 0～99 #* 0-99 is to set the door relay time 0-99 seconds Door Open Detection Door Open Too Long (DOTL) warning.
