PART LIST 1PC Top Panel Left Panel Right Panel Bottom Panel Fixed Shelf 1PC 1PC 1PC 1PC 1PC Rail Door Panel Door Panel Drawer Front Drawer Back Panel Panel 1PC PCS PCS 1PC 1PC Drawer Left Pansy Drawer Right Drawer Bottom | Adjustable Shelf Leg Panel Panel 1PC 1PC 1PC PCS PCS P m Back Panel
HARDWARE LIST ADDITIONAL TOOLS (Not Provided) Note: It is not recommended to use power tools during assembly. / Phillips Head Screwdriver Note: Wood dowels are intended for alignment. Additional clearance between wood dowel and per-drilled hole is intentional for ease of assembly.
Please do not use tools to assemble this unit unless specifically indicated. & S Unlocked Locked Reference the images above any time the instructions state "lock the hardware”. Note: Be sure to check all hardware is locked when completed. Step 1. Attach double magnets (part #3) to fixed shelf (part E) and rail (part F) using round head screws (part #4) and fillips head screwdriver. Attach knob (part #6) to drawer front panel (part ) using short round head bolt (part #7) and fillips head screwdriver.
Step 2. Attach drawer left panel (part K) and drawer right panel (part L) to drawer back panel (part J) using small wood dowels (part #2) and lock the hardware. Slide drawer bottom panel (part M) into grooves of assembled unit (parts Attach drawer front panel (part |) to assembled unit (parts using small wood dowels (part #2) and lock the hardware. #2%x4 Step 3. Lay right panel (part C) upside down on a soft flat surface, such as carpet.
Step 4. Attach left panel (part B) to fixed shelf (part E) and rail (part F) using large wood dowels (part #1) and lock the hardware. #1ex3 Step 5. Attach top panel (part A) and bottom panel (part D) to left panel (part B) and right panel (part C) using bolts (part #9) and Allen wrench (part #15).
Step 6. Attach legs (part O) to bottom panel (part D) using large wood dowels (part #1), flat washers (part #10), spring washers (part #11), bolts (part #9) and Allen wrench (part #15). Step 7. Carefully turn unit upright. Attach back panel (part P) to assembled unit (parts using screws (part #13) and fillips head screwdriver.
Step 8. Slide assembled drawer into place. Attach door panels (parts placing bottom pin hinge (per-installed in door) in the per-drilled hole of bottom panel (part D) and fixed shelf (part E). Then depress the top spring-loaded pin hinge so it can be placed in the per-drilled hole of rail (part F} and top panel (part A). NOTE: Be sure top and bottom pin hinges are fully extended to secure door in place.
Step 9. Place shelf holders (part #12) into desired position and then slide adjustable shelves (part N} into place. Important: Safety strap kit (part #16) must be installed to prevent tipping, damage and/or injury. NOTE: It is important to adjust levelers once fully assembled and upright. Extend adjustable leveler until it's firmly in contact with the floor. If relocating, adjust leveler as needed until it’s firmly in contact with the floor in new location.
De*34" D811z Safety Strap Kit Wall Anchor Washer Short Screw Long Screw Safety Wall Strap 18ET 1PC PCS 1PC 1PC 1PC SAFETY WALL STRAP INSTALLATION Note: It is highly recommended to install this safety strap kit to prevent tipping, damage and/or injury. 1.Insert short screw (C) through washers (B) and safety wall strap (E) and attach to back panel (part P) using fillips head screwdriver. 2.Drill a 11/32" hole where you want to secure the unit.