PART LIST Chair Back Chair Seat Left Support Leg |Right Support Leg Leg Connector 1PC 1PC 1PC 1PC 1PC F Crossbar 1PC M6X40mm M6X38mm M6X13mm Long Bolt Medium Bolt Short Bolt Hex Nut Flat Washer 4 PCS (Extra 1) | 4 PCS (Extra 1) PCS 11 PCS (Extra 2) | 20 PCS (Extra Wrench Allen Wrench | Plastic Washer Round Plastic Washer 1PC 1PC PCS 8 PCS NOTE: We recommend at least two people work together to assemble unit.
Step 1. Lay chair seat (part B) down on a soft flat surface, such as carpet, as shown below. Attach chair back (part A) to chair seat (part B) using short bolts (part #3), hex nuts (part #4), flat washers (part #5), wrench (part #6) and Allen wrench (part #7). NOTE: Please do not fully tighten bolts until unit is fully assembled. # wx4 #_0X Step 2. Attach left support leg (part C) and right support leg (part D) to leg connector (part E).
Step 3. Attach support legs (parts chair back (part A) and chair seat (part B) using long bolts (part #1), Round Plastic Washer (part #9), hex nuts (part #4), flat washers (part #5), plastic washers (part #8), wrench (part #6) and Allen wrench (part #7). NOTE: Please do not fully tighten bolts until unit is fully assembled.
Step 4. Attach crossbar (part F) to left support leg (part C) and right support leg (part D) using medium bolts (part #2), Round Plastic Washer (part #9), hex nuts (part #4), flat washers (part #5), wrench (part #6) and Allen wrench (part #7). NOTE: Please fully tighten all bolts at this time.