Instructions / Assembly

Lighting Instructions

1. Press and hold electronic igniter button.

2. Turn the burner control to the low position,

press and hold. When the burner lights, release

the electronic igniter button.

3. Continue to depress the burner control knob for

30 seonds and then release. If the flame goes out,

repeat the procedue.

4. Adjust the flame to the desired height with the

burner control knob. Visually check the burner

flames as pictured below.

5. If the burner will not light with the electronic

igniter, hold a lit long match or lit long butane

lighter to the ignition area of the burner and

continue with step 2.

6. To shut down the burner turn the burner control

knob clockwise to the off position. Then turn the

gas off at the source (propane cylinder valve).

Normal

WARNING

FOR YOUR SAFETY:

Keep face and body away from

burner area when lighting.

Ensure burner controls are in the off

position.

Slowly turn on the gas supply valve.

WARNING

FOR YOUR SAFETY:

The propane cylinder is equipped

with an excess flow device. Unless

burners are turned off prior to turning

the cylinder on, only small flames

and low heat will be achievable.

WARNING

FOR YOUR SAFETY:

The propane cylinder is equipped

with an excess flow device. Unless

burners are turned off prior to turning

the cylinder on, only small flames

and low heat will be achievable.

WARNING

FOR YOUR SAFETY:

Surface of the fire pit can remain

extremely hot for a period after use.

Allow 45 minutes to cool down

before touching or moving the fire pit.