CR6008A Tech Series 910-292100-0010-200 www.crosleyradio.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
IMPORTANT SAFETY INSTRUCTION General PLEASE READ CAREFULLY ALL THE FOLLOWING IMPORTANT SAFEGUARDS THAT ARE APPLICABLE TO YOUR EQUIPMENT 1. 2. 3. 4. 5. Troubleshooting There is no Power 1 Make sure radio is plugged in correctly. 2 The unit is not turned on: Rotate the VOLUME ON/OFF KNOB from the OFF position past the click to turn on the unit. USB /SD Card - no music is playing when PLAY/PAUSE is pressed 1 Make sure there are MP3 music files stored on the USB Device/Flash Drive / SD Card.
Welcome Thank you for purchasing the Crosley Tech Series Turntable (CR6008A) Before operating this unit, please read this manual thoroughly and retain it for future reference. About This Manual Instructions in this manual describe the control functions of the CR6008A. Included in the package: Tech Series Turntable Remote Control AC Power Adaptor 45 RPM Adaptor 3.5mm to 3.5mm STEREO cable Audio / Connections Table of Contents Getting Started Unpacking............................... 4 Power Source.........
Audio / Connections Phono to USB/SD This unit allows you to convert your records into MP3 format onto either USB Flash Drive or SD Card. To convert your records, follow the steps below. 1. Slide the FUNCTION button to PHONO mode. 2. Start playback of the record at the point you want to start recording. (See Turntable Operation on Page 7 for more information on playing your records). to start recording. 3. Press REC/ERASE / REC will show on the display. 4.
Control Locators BACKWARD SKIP FORWARD SKIP FUNCTION SWITCH SD CARD X-BASS ON/OFF PROGRAM/ REPEAT POWER INDICATOR REC/ ERASE SENSOR Programmed Playback PLAY/PAUSE LCD DISPLAY FM.ST INDICATOR OPEN/ CLOSE STOP/ SD/USB Basic Operation USB PORT AM\FM\FM.ST SWITCH Up to 20 tracks can from a CD, USB drive or SD Card can be Programmed to play back in a desired sequence. To program Tracks, follow the instructions below. 1.
Basic Operation Control Locators SD-Card Operation SPEED CONTROL SWITCH 1. Switch the unit on by turning the VOLUME ON/OFF KNOB to The ON position 4. Turn the volume to a mid-range position. 5. Plug-in USB mass storage device. READ is displayed as the system scans the contents of USB device. 2. Slide the FUNCTION SWITCH to CD mode for 3 seconds to 3. Press and hold the STOP / Switch to SD Card Mode. The display will read "CARD" once the Unit is in SD Mode. 6. Track no.
Basic Operation Turntable Operation Turn the unit on by rotating the VOLUME ON/OFF KNOB located on the front panel to the ON position 1 Set the FUNCTION SWITCH to PHONO mode. 2 Set the SPEED CONTROL SWITCH to the desired speed (33 1/3, 45 or 78 rpm). Place your record onto the turntable. 3 Move the TONE ARM slightly to the right side until you hear a click sound to activate the turntable. 4 Move the TONE ARM by hand over the record to the point you want the record to start.
