Specifications

11
MP3 copying
1. To copy an individual song from either USB to
SD or SD to USB, press REC/ERASE /
while the desired song is playing to start copying.
Playback will stop as the system scans the
contents and prepares to copy the song.
2.  REC " icon will show on the display.
3. COPY will show on the display as copying
begins.
4. The icon for the device that you are copying
to, USB or CARD will begin flashing and
will stop once copying is complete.
5. Original source, USB or SD will begin playing
from the beginning once copying is complete.
6. You can also copy all songs at once from USB
to SD or SD to USB. While in either USB or
SD mode and playback is stopped, press
REC/ERASE /
. The unit will copy all songs
from the USB to SD or from the SD to USB.
You will not be able to stop the copying process
until complete.
This unit allows you to convert your records into
MP3 format onto either USB Flash Drive or SD
Card. To convert your records, follow the steps
below.
1. Slide the FUNCTION button to PHONO mode.
2. Start playback of the record at the point you want
to start recording. (See Turntable Operation on
Page 7 for more information on playing your
records).
3. Press REC/ERASE /
to start recording.
 REC  will show on the display.
4. The media that you are recording to (either USB
or SD) will begin flashing on the display once
recording begins.
5. Press STOP /
to stop the recording process.
This units allows you to delete individual songs from
your SD Card or USB Flash Drive. To erase a
particular song, that song must be playing.
1 While in SD/USB mode, select the song you
would like to delete and begin playback.
2 Once the song is playing, press and hold the
REC/ERASE / button for approximately
2 seconds. The song will stop playing and will
be deleted.
3 The display will briefly show delete"
Note: You can only erase one song at a time. You
cannot erase the entire SD Card or USB Drive at
one time.
Phono to USB/SD
MP3 Copying
Audio / Connections
MP3 Recording
Recording from CD to USB / SD
The system is capable of converting (encoding) a
whole Audio CD into MP3 format and copy/record
this to a USB mass storage device (e.g. a Flash
Drive) or SD card (not supplied). It can also copy
a single MP3 track to/from a USB device or SD card.
1. In CD playback mode, press REC /
to start
ripping (recording) to USB/SD card (the default
is USB if both devices are detected), playback
will stop and skip back to the beginning of the
current track, the system will scan the contents
of the USB/SD Card and create a folder to store
the MP3 Tracks in. Resume CD playback and
ripping will start from that moment.  USB  or
 CARD  will start flashing, depending on the
device selected.
2. Press STOP /
to exit CD ripping.
Deleting MP3 Tracks
1 Remove packing materials from unit.
Note: Save all packing materials.
2 Remove plastic bag covering radio.
3 Remove AC Adaptor from Packing.
4 Open lid and remove styrofoam shipping material
from turntable.
5 Remove black tie-wrap from under the tone arm.
6 Remove white protective needle cover by gently
pulling towards the front of the unit.
7 Install the top lid onto the unit.
SETUP
1 Untie the wire on the AC Adaptor.
2 Untie the FM antenna and allow it to hang down
in a straight line for optimum FM reception. If
you have trouble tuning a FM station, move the
external FM antenna for best reception. Do not
connect FM antenna to outside antenna.
1 Plug the AC Adaptor into appropriate wall outlet.
2 Plug the small end of the adaptor into the AC
ADAPTOR JACK on the back of the unit.
4
1 Flip the LID LOCK HINGE towards the back of
the unit.
2 Position LID over the turntable and press the lid
onto the LOCK HINGE as shown below.
3 As you press the lid into place, align the PIVOT
PINS on the LID with the LID PIVOT POINTS as
shown below.
4 Press the LID all the way in until the PIVOT PINS
snap into the LID PIVOT POINTS and the LOCK
HINGE clicks into place.
Getting Started
Unpacking
Power Source
Lid Installation
click