User Manual

English
8
Turntable Platter and Belt Setup
1. Install the drive belt over the inner ring under the platter and make sure it
won’t fall off during the setup.
2. Place the platter through the turntable spindle, then rotate the platter until you
see the drive motor pulley through the window at the top right corner.
3. Carefully grab the drive belt and put it around the slot of motor pulley.
Phono/Line Switch
For increased flexibility of use, this unit has a built-in stereo phono pre-amplifier.
If you prefer to use the phono input of your stereo system or your standalone
phono pre-amplifier, set the Phono/Line switch to the PHONO position.
Otherwise, please set it to LINE position and make connection to the AUX input
or other high-level input on your stereo system.
Stereo System Connection
RCA Jacks
 The RCA Jacks of this unit are shared as both the Phono output jacks and the
Line output jacks. They are determined by the Phono/Line Switch.
 When used as a line output, the jacks output analog line-level signals and
could be connected directly with a pair of active speakers or the appropriate
input of your stereo system. When used as a Phono output, they should be
connected to the phono pre-amp or the phono input of the stereo system.
 The Red plug connects with the Right channel and the White plug connects
with the Left channel.
Note:
 If the Phono/Line switch is set at LINE position but RCA jacks connected to the
stereo system’s phono input, the sound might be distorted due to input overload
and could damage your stereo system.
 If the Phono/Line switch is set at PHONO position but RCA jack connected to the
stereo system’s line input, the volume will be very low due to lacking signal pre-
amplification.
 RCA Jack is not designed to be connected directly to the passive/unpowered
speakers and if it does, the volume will be very low.