C3A C3 Turntable Instruction Manual Questions, problems, missing parts? Before returning to the store, call Customer Service 8 a.m. – 6 p.m., EST, Monday – Friday 1-888-CROSLEY www.crosleyradio.
English Safety Instructions Read and understand this entire manual before using this product. Keep these instructions for future reference. 1. Do not use this product near water. 2. This product should be operated only by the type of power source indicated on the marking label or in this instruction manual. 3. Do not defeat the safety purpose of the polarized plug. A polarized plug has two blades with one blade wider than the other. This plug will fit into the power outlet only one way.
English Specifications Crosley C3A Power Power Consumption Turntable Speed Speed Variance Wow and Flutter Signal to Noise Downforce Range Effective Tonearm Length Overhang Product Dimensions(W x H x D) Weight AC power adapter, DC output 12V, 1A 9W 331/3, 45 RPM 3000Hz +3/-2% (2960-3090Hz) < 0.3% 35-40dB 3.5 ±5%gr 221.6 mm 16.2 mm 422x97x482mm 8 LBS Needle NP-5 Frequency Response 20Hz-20KHz Channel Balance ±2.
English Product Description 1. 2. 3. 4. 5. 6. 7. 8. Drive Pulley Drive Belt Turntable Platter Turntable Spindle Turntable Hub Speed Selector Tonearm Lift Tonearm Counterweight 9. 10. 11. 12. 13. 14. 15. 16.
English Initial Setup Essential Setup 1. Place the unit on a flat and level surface. The selected location should be stable and free from vibration. 2. Remove the tie-wrap that is holding the tonearm. 3. Install the turntable platter and drive belt accordingly 4. Place the slip mat on top of the turntable platter. 5. Slide Tonearm Counterweight onto tonearm and twist it lightly onto the rear shaft of the tonearm. 6. Adjust the counterweight to set proper stylus pressure. 7.
English Turntable Operation 1. Turn the Speed Selector to the desired speed. 2. Place the record on the turntable. Use the 45 RPM Adapter if necessary. 3. Remove the stylus protector from the stylus assembly. Note: To avoid stylus damage, make certain the included stylus guard is in place whenever the turntable is being moved or cleaned. 4. Gently pull up the Tonearm from its rest and move it over the record where play is desired to begin.
English Troubleshooting There is no power • Power adaptor is not connected correctly. • No power at the power outlet. Power is on, but the platter does not turn • Turntable’s drive belt is not installed or has slipped off. Turntable is spinning, but there is no sound, or sound not loud enough • Stylus protector is still on. • Tone arm is lift up by the lever. Record sounds too fast or too slow. • Wrong speed selected for the record.