User Manual

English
6
Turntable Operation
1. Press the Power Switch to turn on the power. The turntable will automatically start searching for an external Bluetooth
speaker.
Note: Please ensure there is no Bluetooth speaker within 30 feet working under pairing mode to prevent accidental Bluetooth connection
establishment.
a. Once the Bluetooth speaker is successfully paired, the Bluetooth indicator will be solid blue.
Note: If no Bluetooth speaker is paired with the turntable within 2 minutes, the turntable will de-active the Bluetooth searching function.
When you decide to connect the turntable to Bluetooth speaker later on after the 2-minute period, you will need to turn OFF the
turntable and start over from Step 1 above.
2. Set the Speed Switch accordingly.
3. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
4. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place whenever the turntable is being moved or cleaned.
5. Gently pull up the Tonearm from its rest and move it over he record where play is desired to begin. Use the Tonearm Lift
Lever to raise the Tonearm Lift and let the Tonearm sit on it.
6. Set the Tonearm Lift Lever back to the down position, the tonearm will descend slowly onto the record and begin
playback.
7. When the record is finished playing, use the Tonearm Lift Lever to raise the tonearm and then return it to the Tonearm
Rest. To suspend the playback, repeat the same steps.
Cartridge Replacement
1. Before replacement, put the stylus protector back on the stylus to prevent damage to the stylus during the
replacement process.
2. Carefully remove the wire leads from the original cartridge.
3. Loosen the two screws on the headshell that are securing the cartridge and then remove the original cartridge.
4. Mount the new cartridge to the headshell and tighten it lightly. Do not completely tighten the screws at this moment.
5. Connect the wire leads to the new cartridge’s terminals .The wire lead color codes are as below:
White Left channel positive (L+)
Black Left channel negative (L–)
Red Right channel positive (R+)
Black Right channel negative (R-)
6. Adjust the cartridge’s position to make sure it is precisely aligned on the headshell so that the stylus will be tracking
the grooves in parallel perfectly.
To achieve this, place the included paper cartridge alignment protractor over the turntable spindle, carefully lift the
tone arm and place the tip of the stylus on the points marked 130mm and 250mm respectively. Fine tune the
cartridge’s position on the headshell until the cartridge is perfectly in parallel with the reference lines at both points.
7. Tighten the screws completely once the perfect alignment is achieved.
Azimuth Adjustment
The needle must be perpendicular to the record groove in order to track the groove wall
modulations correctly. In rare cases, if the factory installation is not perfect, you can make below
adjustment:
1. Use an Allen Wrench to loosen the screw located at the bearing end of the tonearm just enough
to loosen the arm tube.
Note: Do not remove the screw completely.
2. Gently rotate the tonearm until the needle is perpendicular to the record surface.
Note: Make sure the needle tip is not touching the record when adjustment is being made or it will cause
damage to the needle and cantilever suspension.
3. Tighten the screw when adjustment is finished.
Turntable Maintenance
1. Do not touch the stylus tip with your fingers. Avoid bumping the stylus on the turntable mat or a record’s edge.
2. Clean the stylus frequently with a soft brush with a back-to-front motion only.
3. Clean the records to get rid of dust or grease with a record cleaning brush and record cleaning solution.
4. Clean the turntable lid and turntable cabinet with a slightly damped microfiber cloth.
Note: Do not use cleanser other that contains alcohol, benzene or any other harsh chemicals, which might damage the paint and finish
of the turntable.
** Crosley offers a product line of different cleaning accessories. Please ask your retailer or check out
our website www.crosleyradio.com for more cleaning product information.