Installation guide

ManualsBrandsCrosley ManualsRoom air conditionerOfficial Crosley air conditioner

|nstallation instructions

READ BEFORE iNSTALLiNG UNiT

Compact Window Mounting

Your air conditioner is designed to install in standard

double hung windows with opening widths of 23 to 36

inches (584 mm to 914 ram) (FIG. l)

Lower sash must open sufficiently to allow a clear vertical

opening of 14-1/2 inches (368 mm). Side louvers and the

rear of the AC must have clear air space to allow

enough airflow through the condenser, for heat removal.

The rear of the unit must be outdoors, not inside a

building or garage.

Fig. 1

EXTERIOR

NOTE: SAVE CARTON and these INSTALLATION

INSTRUCTIONS for future reference. The carton is the

best way to store unit during winter, or when not in use.

Some assembly is required. Please read these instructions

carefully.

Mounting Hardware

3/4" screws

lock flame

sash lock

TOOLS NEEDED:

• PhillipsScrewDriver

, Drill(Ifpilotholesareneeded)

NOTE: DO NOT USE ANY SCREWS OTHER THAN

THOSE SPECIFIED HERE

When handling unit, be careful to avoid cuts

from sharp metal edges and aluminum fins on

front and rear coils.

Before installing unit, the top rail must be

assembled on the unit.

Top Rail Hardware Qty.

3/8" Screw 4

Top Rail l

TOOL NEEDED:

, Phillips Screwdriver

Top

Rail

A. Remove the air

conditioner from the

carton and place on a

fiat surface. Packaging

B. Remove top rail from

the rear of the

packaging material as

shown in Fig. A

C°

Align the hole in the

top rail with those in

the top of the unit as

shown in Fig. B

Secure the top rail to

the unit with the 3/8"

Screws as shown in

Fig. C

NOTE: FOR SAFETY REASONS, ALL

FOUR (4) SCREWS MUST BE SECURELY

FASTENED.

P/N 2020215A0201

Summary of content (3 pages)

PAGE 1
|nstallation instructions READ BEFORE iNSTALLiNG UNiT Compact Window Mounting Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 ram) (FIG. l) Lower sash must open sufficiently to allow a clear vertical opening of 14-1/2 inches (368 mm). Side louvers and the rear of the AC must have clear air space to allow enough airflow through the condenser, for heat removal.
PAGE 2
How to Install NOTE: "Fop Rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained! Place unit on floor, a bench or a table. There is a Left and Right Window Filler Panel - be sure to use the proper panel for each side.
PAGE 3
Place the extensions frame lock between the frame and the window sill as shown (Fig. 8). Drive 3/4" (19 ram) Cut foam seal and insert between the upper and in the space lower sashes (riG.13). locking screws through the frame lock and into the sill (FIG. 9). NOTE: To prevent window sill from splitting, drill 1/8" (3 ram) pilot holes before driving screws. IfAC is Blocked Window by Storm Add wood as shown in FIG. 14, or remove storm window before air conditioner is installed. FiG.