User guide

4
Getting ready to use your new jukebox
If you followed the unpacking instructions on page
1, you should have found the remote, the FM
antenna and documentation attached to the foam
packing material. If you have not already done so,
remove the plastic protector from the AC power
cord. Unwrap the antenna, (shown at right in photo)
and attach it to the antenna terminals on the back of
the jukebox. See photo below.
The remote uses 2 AAA size batteries (not included).
Open the battery compartment on the back of the
remote and insert batteries. Replace battery
compartment door and set remote aside for now.
Special Note: There are two pieces of clear tape
across the front of the CD player drawer to protect it
from opening during shipment. Remove this tape
before powering up the jukebox to prevent damage
to the CD player.
Tools and supplies required
to complete these steps:
Small flat blade screwdriver
2 AAA size batteries
Next, connect the jukebox AC power cord to a wall outlet. NOTE: This product may be
equipped with a polarized alternating current line plug (a plug having one blade wider
than the other). This plug will fit into the power outlet only one way. This is a safety
feature. If you are unable to insert the plug fully into the outlet try reversing the plug. If
the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do
not defeat the purpose of the polarized plug.
The photo at right shows the
accessory terminals on the back
of the jukebox.
FM Antenna - connect as
described above.
Aux. Inputs – connect your
MP3 player here.
12V Output – to power other
accessories.
Lighting – hold or alternate
shifting LED accent lights.
Speaker Int. / Ext. – Move
switch to Ext. if you are using
external speakers.
EXT Speaker – Spring clip
terminals let you connect
optional external speakers.
NOTE: Make sure that the speaker switch is set to
INT. (internal speakers) unless you have optional
external speakers attached.