PART LIST Top Panel Left Side Panel | Right Side Panel | Bottom Panel Glass Door 1PC 1PC 1PC 1PC 1PC Back Panel Adjustable Shelf Rail Support Plate 1PC PCS 1PC 1PC 28°30mm Wood Dowel Handle Round Head Bolt Shelf Holder Long Round Head Screw 20 PCS(Extra 1) 1PC 3PCS(Exira1) | 9 Extractor) | 3 PCS(Extra 1) #5 Wall Anchor PCS ADDITIONAL TOOLS (Not Provided) Note: It is not recommended to use power tools during assembly.
Please do not use tools to assemble this unit unless specifically indicated. Unlocked Reference the images above any time the instructions state "lock the hardware". Note: Be sure to check all hardware is locked when completed. Step 1. Attach handle (part #2) to glass door (part E) using round head bolts (part #3) and fillips head screwdriver.
Step 2. Lay top panel (part A) upside down on a soft surface, such as carpet, as shown below. Attach rail (part H) to top panel (part A) using wood dowel (part #1). #sexless Step 3. Attach left side panel (part B) and right side panel (part C) to top panel (part A) and rail (part H) using wood dowels (part #1) and lock the hardware.
Step 4. Slide back panel (part F) into grooves of left side panel (part B), right side panel (part C) and top panel (part A). Step 5. Attach bottom panel (part D) to left side panel (part B), right side panel (part C) and back panel (part F) using wood dowels (part #1) and lock the hardware.
Step 6. Attach glass door (part E) to top panel (part A), left side panel (part B), right side panel (part C) and bottom panel (part D) using wood dowels (part #1). Open the glass door and lock the hardware. #1%x6 Step 7. Carefully turn unit upright. Place shelf holders (part #4) into desired position and then slide adjustable shelves (part G) into place.
Step 8. Hold support plate (part I) in the desired location of cabinet. The support plate (part 1) will be about 2" lower than the top of cabinet. Making sure support plate (part 1} is leveled, use a pencil to mark wall anchors locations using the support plate (part 1) screw holes as a guide. We recommend using a leveler to make sure support plate (part I) is oriented correctly. Drill two 11/32" holes in these marked spots and tap wall anchors (part #6) into the drilled holes.
