PART LIST Back Panel 1pc A 1pc B 1pc Top Panel 1pc E 1pc C Bottom Panel Left Panel D Right Panel Front Panel 1pc F HARDWARE LIST Short Bolt (M6*10mm) 3pcs G Flat Washer(M6mm) K 18pcs Mid Bolt (M6*20mm) H 4pcs Plastic Washer L 4pcs Long Bolt (M6*40mm) 14pcs I Inner Thread Bolt (M6*40mm) 3pcs J Hinge Support Allen Key(M6mm) M 2 2pcs N 2pcs
Step 1. Lay Front Panel ( B ) down on a flat surface, attach Right Panel (C) and Left Panel (D) to Front Panel (B) using a Long Bolt (I) and Flat Washers (K). Note: Please do not tighten bolts before fully completing all assembly steps. Step 2. Attach Bottom Panel (E) to Right Panel (C), Left PaneL (D) and Front Panel (B) using a Long Bolt (I) and Flat Washer (K).
Step 3. Attach Back Panel ( A ) to Left Panel (D), Right Panel ( C ) and Bottom Panel ( E ) using a Long Bolt (I) and Flat Washer (K). Step 4. Carefully turn over the box so that the legs are on floor. Attach Hinge Support ( M ) to Left Panel (D) and Right Panel (C) using a Mid Bolt (H), Flat Waher (K) and Plastic Washer (L).
Step 5. Attach Top Panel ( F ) to the Back Panel ( A ) using a Inner Thread Bolt ( J ),Short Bolt (G) and Alley Keys ( N) Step 6. Open Top Panel (F) and then attach Hinge Support ( M ) to Top Panel ( F ) using a Mid Bolt ( H ), Flat Waher (K) and Plastic Washer(L).
Step 7. Top Panel (F) can be opened and closed.