Outdoor Wicker Arm Chair CO7318
PART LIST C B A Right Arm Panel 2 PCS Left Arm Panel 2 PCS D Seat Panel 2 PCS E Back Panel 2 PCS G F Seat Cushion 2 PCS Back Cushion 2 PCS HARDWARE LIST #2 #1 M6*15mm #3 M6*30mm #4 M6mm Long Bolt Flat Washer Short Bolt 24 PCS (Extra 1) 14 PCS (Extra 1) 38 PCS (Extra 1) 2 M6mm Allen Wrench 1 PC Leg 8 PCS
Step 1. Lay right arm panel (part A) upside down on a soft flat surface, such as carpet, as shown below. Attach back panel (part D) to right arm panel (part A) using long bolt (part #2), flat washer (part #3) and allen wrench (part #4). NOTE: Please do not fully tighten bolts until unit is fully assembled. #4 D A #2 #3 #2 x1 #3 x1 #4 x1 Step 2. Attach seat panel (part C) to right arm panel (part A) and back panel (part D) using long bolts (part #2), flat washers (part #3) and allen wrench (part #4).
Step 3. Attach left arm panel (part B) to back panel (part D) and seat panel (part C) using long bolts (part #2), flat washers (part #3) and allen wrench (part #4). NOTE: Please do not fully tighten bolts until unit is fully assembled. #3 B #2 D C #4 #2 x3 #3 x3 #4 x1 Step 4. Carefully turn assembled unit upside down. Attach legs (part E) to assembled unit (parts A, B & D) using short bolts (part #1), flat washers (part #3) and allen wrench (part #4).
Step 5. Carefully turn unit upright. Add seat cushion (part F) and back cushion (part G) as shown below. Repeat steps 1-5 to assemble remaining chair.
