CR56 1950’s Classic Pay Phone Instruction Manual 910-008800-0420-200 R1 www.crosleyradio.
ENGLISH FCC Requirements 1. This equipment complies with 47CFRPart 68 and ACTA technical requirements. On the bottom of this equipment is a label that contains, among other information, the registration number and ringer equivalence number (REN) for this equipment. If requested, this information must be provided to the telephone company. 2. The USOC number of the registration jack for the equipment is RJ11C/RJ11W. 3. A FCC compliant telephone cord and modular plug is provided with this equipment.
ENGLISH TROUBLESHOOTING If you experience problems with your telephone, try the following suggestions: NO DIAL TONE 1. Make sure that all plugs are connected properly. Check the connections at the wall jack, the telephone body and the handset. 2. Try another modular jack within your home which you know to be working properly. CALLS CANNOT BE DIALED OR DIALED SLOWLY Check to make sure that the DIAL MODE switch is in the correct position for the type of service available in your area.
ENGLISH LIMITED MANUFACTURERS WARRANTY Crosley Radio, Inc. warrants the product to be free from defects in material and workmanship under normal use for a period of one year from the original date of purchase. This warranty is not transferable. If the product is determined to be defective during the warranty period, the unit will be repaired or replaced at Crosley Radio’s sole discretion.
ENGLISH IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions, should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4.
ENGLISH SET UP DIAL MODE Locate the DIAL MODE switch on the rear of the telephone body. Slide the switch to TONE unless you have Dial-Pulse (Rotary) telephone service in your area in which case, slide the switch to the PULSE position. RINGER CONTROL The RINGER CONTROL switch on the rear of the telephone allows you to turn the ringer ON or OFF. You can still make or receive calls with the ringer in OFF position, however, you will not hear the incoming ring.
ENGLISH LOCATION OF PARTS DIAL REDIAL BUTTON ( coin release) TELEPHONE BODY MOUNTING HOLES COIN SLOTS HANDSET CRADLE RINGER CONTROL ON/OFF HANDSET DIAL MODE TONE PULSE RECEIVER VOLUM HI/LOW HEADSET CORD JACK HEADSET CORD JACK HANDSET CORD CHANNEL LINE CORD JACK SPACE PADS COIN BOX
ENGLISH TOP KEY HOLE A USE THIS TEMPLATE TO DETERMINE THE POSITION OF TELEPHONE ON WALL, AND WHERE TO LOCATE SCREW HOLES.