User's Manual

The audio Jacks output analog line-level signals and could be connected directly with a pair of active/powered speakers or the appropriate input of
your stereo system.
Note:
1. The Audio Jacks are not designed to be connected directly to the passive/unpowered speakers. If connected to the passive speakers, the volume
level will be very low.
2. If want to mute the unit, please hold and press the “ ” button to mute the unit or unplug the speakers from Out L/R jack.
Trouble Shooting
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance
could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
Problem
Solution
There is no power
-Power cord is not properly connect
-No power at the power outlet.
There is no sound from the speakers
-
The speakers could not be connected to my Bluetooth device
-The device’s Bluetooth function is not turned on.
-The speakers are actively connected to another Bluetooth device.
The turntable speaker stop before the record is finished.
-Adjust the Auto-stop switch to “OFF” position.
In “Bluetooth Out” function, the unit and bluetooth receiver
do not connect successfully
-Turn the unit and bluetooth receiver off. Follow the pairing step again from the
beginning.
-Check whether the turntable unit connect with another bluetooth receiver.
The record function cannot work.
-Please make sure that the USB is plugged in if require to record.
-USB is not properly inserted