Service Manual

Page 17.D
The magazine feed is staked into the Frame R.H. If it becomes necessary
to service the magazine, remove as much of the staking as practical and
pry out magazine cover 45-4 with a screwdriver exposing Magazine Slide
45-35 and Magazine Spring 45-36. Replace defective parts and re-stake
cover with a hand punch.
After reassembly test BB Retainer for proper functioning by loading
magazine and firing several BB's. Then cock gun and with muzzle pointed
down shake gun. BB Should not fall out.
To repair valve assembly, disassemble valve, blow out any chips in
valve and replace valve stem.
To replace "0" Ring which fits around neck of Powerlet, remove old "0"
Ring with pen knife. Install new "0" Ring, 45-17, with tweezers or
blunt instrument.
If the cylinder does not revolve easily after assembly, tap lightly
with a rawhide mallet to properly seat cylinder.