Service Manual

PAGE 19 – C

DISASSEMBLY PROCEDURE FOR C0

SEMI-AUTOMATIC MODEL "600" (REFER TO DRAWINGS PAGE: 19.1)

NOTE: BE

SURE UNIT IS DISARMED

1. Exhaust residual C0

gas by continual cocking with operating slide; if necessary, until gun is empty.

2. Insert 3/16 diameter Ramrod in Muzzle end of Barrel, to be sure of clear Barrel.

3. Insert small diameter rod in Pell aperture on left side of Frame to be sure of a clear Swing Arm.

4. Remove Tube Cap Assembly (600-73) to insure the unit is disarmed.

5. Remove Pellets from Magazine.

SIGHT ASSEMBLY

1. Unscrew Sight Screw (600-17) holding down Sight Assembly (600-12) to prevent binding on Screw.

2. Remove Sight Ball (600-6) and Pivot Sight Assembly (600-12) up above forward tongue.

3. Disassembly of Sight Assembly (600-12): Remove Blade Screw (600-16) Freeing Sight Blade (600-14) and Spring (600-64) for

removal.

CAM GROUP

1. Remove Sight Assembly

2. Unscrew and remove Cover Screw (600-24) freeing Lock Washer (140-89), Cover (600-23) and Cover Pin (600-7). CAUTION:

Magazine Spring may fly out.

3. Unscrew and remove Two (2) Feed Arm Screws (600-52) and (400-11).

4. Remove Cam (600-40) with slight clockwise rotation using long nose pliers or tweezers or turn the gun muzzle up and tap back of

gun on bench or hand and Cam will drop out.