Service Manual

Page 19 - G
CAM GROUP, ASSEMBLY
1. Make sure Ring (600-29) is a good sliding fit on Cam (600-40), before assembly.
2. Make sure Hammer is in forward position.
3. Very lightly coat Swing Arm with lubriplate or equivalent good grease.
4. Insert Cam into Ring in correct position to line Drill spot up with Screw of Feed Arm when in down or fire position. Be sure
Screw is in center of Drill spot before tightening. This can be done by moving Feed Arm back and forth to get feel of center.
5. This Cam must be lubricated with lubriplate or equivalent good grease.
6. Feed Arm set screws must be tight and Feed Arm must have freedom of movement when gun is in cocked position.
BARREL, ASSEMBLY
1. Slide Barrel into Frame and allow .003 thousands with a Feeler Gauge between Feed Arm and chambered end of Barrel.
2. Insert and tighten set screw (160-33).
3. Remove Feeler Gauge.
SIGHT GROUP
1. Small Sight Ball may be held in seat with small amount of grease.
2. Windage Screw (600-16) requires small amount of lubriplate on Click Grooves at base of Screw.
TRIGGER GROUP
1. All Pins (600-4, 600-5 & 600-49), should be lightly coated with lubriplate, before assembly.