Service Manual

Page 19 - H
HELP NOTES FOR POSSIBLE MALFUNCTION AND ADJUSTMENT FOR MODEL "600"
1. Be sure Cocking Slide Is always returned to extreme forward position after cocking gun.
2. Do not at any time attempt to force swing arm with screw driver or other tools as this will cause damage to Cam Ring.
3. (A.) Feed Arm must line up with hole in Magazine. This can be checked by using a .22 caliber Pellet. Place Pellet in
Magazine, cock Pistol, point Muzzle end down, Pell should drop into Swing Arm freely. (See Item # 4 - Cam Group
Assembly - Page 19 - E).
(B.) Fire Pistol so that Feed Arm is now in fire position, tap back of Cam with suitable tool and assemble and tighten Lock Set
Screw (400-11).
4. When replacing Ring (600-29) or Cam (600-40), Ring and Cam Assembly must be mated to insure a smooth easy action over
the twist. Apply lubriplate or equivalent.
5. If Pellet fails to feed freely out of Magazine, check Magazine Pell Loading Aperture for possible burr caused by slamming action
of Pell Follower Knob against casting. Deburr if necessary.