Service Manual

Page 20 - A
DISASSEMBLY PROCEDURE FOR SLIDE ACTION BB AIR RIFLE
MODEL V – 350
Refer to Drawing – Page 20.1
1. Remove 2 Lock Screws (V-350-19).
Remove Stock.
Barrel Lock (V-350-16) and Spring (V-350-24) will fall out of Stock.
Clamp Tube (V-350-1) upside down in vise with protected jaws.
2. Loosen Guide Screw (V-350-10) slightly.
Unscrew Tube Bearing (V-350-3).
Push Barrel back into Tube slightly. Hold and remove Guide Screw.
Pull Barrel Assembly out of Tube. Use care not to loose Ball Spring (V-350-17) and Ball (105-39).
3. Drive Locating Stud (V-350-9) out of Tube. Drive on tapped end so stud is driven out thru top of Tube.
Remove Tube Plug and Stop Assembly (V-350-35) and Piston Spring (V-350-27).
Push Hammer and Piston Assembly (V-350-36) out of Tube with rod, using care not to damage Teflon Piston.
4. Clamp Barrel (V-350-2) in vise and remove Barrel Cap (V-350-4) with snap-lock pliers.
When reassembling Barrel Cap to Barrel, secure Assembly with a small quantity of Loc-Tite Grade C Liquid Sealant. Also use a
small quantity on Guide Screw (V-350-10) and Front Sight Screw (160-28).
Lubricate Barrel Lock and Trigger with Lubriplate Grease.
Lubricate Barrel Lock and Trigger with Lubriplate Grease.