Service Manual

Page 6-A
DISASSEMBLY PROCEDURE FOR C0
2
RIFLES MODELS 113-114 REFER TO DRAWINGS PAGE 6.1, 6.2, 10.1.
Follow instruction for disassembly of rear portion of rifle Page 3.A Items (1-2), and front portion,
Filling Head, Item 4 Page 10-A.
EXHAUST VALVE DETAIL IS SHOWN IN DRAWING PAGE 10-4.
Remove dirt from Chamber and Valve parts before assembling.
NOTE: Exhaust Valve Nut (121-6) must be tight on Stem (105-12).
Examine metal and rubber seats for damage, replace if necessary.
Valve Nut (110-18) must be tight to prevent leak around Gasket (105-31).
Line up blind hole in Exhaust Valve Body thru bottom of Tube with Locating Pin (T-3), and hold in place while
tightening Valve Nut.
FILLING HEAD DETAIL IS SHOWN IN DRAWING PAGE 10.3 INSTRUCTIONS GIVEN ON PAGE 10-A.
id3248991 pdfMachine by Broadgun Software - a great PDF writer! - a great PDF creator! - http://www.pdfmachine.com http://www.broadgun.com