Service Manual

MODEL 118 Page 7-A

DISASSEMBLY PROCEDURE FOR C0

REPEATER RIFLE ----------REFER TO DRAWINGS PAGE 7.1, 7.2

1. Valve system of this model is same as shown in drawing Page 10.1, 10.4.

Instructions for disassembly and repair are on Page 10-A.

2. Firing mechanism is same as shown in drawing Page 6.1.

Instructions for disassembly and repair are on Page 3-A.

3. Filling Head is same as shown in drawing Page 10.3.

Instructions for disassembly and repair are on Page 10-A.

4. Feeding mechanism is assembled into Breech (118-1). Pells are transferred from magazine

assembly (118-113) into chamber end of Barrel (118-10) by swing cam assembly (118-96).

Swing cam assembly is actuated by Cam plate (118-8) by action of cocking lever (118-2) and

cocking shaft and post assembly. Free movement of these parts is necessary for correct

action. Pawl (118-36) engages in notch of cocking shaft when rifle is cocked to prevent

double loading of pells. Rifle cannot be cocked second time unless it is fired. Anti-cocking

pin (118-40) releases pawl when rifle is fired. Breech Bolt (118-12) is sealed at chamber

end of barrel with “O” ring (130-33) to prevent gas blow back. Seal adjustment is made with

adjusting nut (118-14). Cover (118-6) must fit snug on cover pin (118-31) and ear at rear of

cover must snap into groove on breech at magazine hold to insure proper cam action of feeding

mechanism.

Front sight and Breech are silver soldered to Tube.

Barrel is sealed at air port with a rubber gasket to prevent C0

from escaping.